Back to Coatings

 

 

 

 

 

4.210 GEMSOLV 2P

EPOXY THINNER

 

  • Composition and Properties

  • GEMSOLV 2P is a low toxicity environmentally friendly solvent for thinning GemCo epoxy products .

  • It is biodegradable and based on a citrus extract.

  • It can also be used for degreasing & cleaning of a variety of substrates.

  • Physical properties

  • Appearance: water white liquid

  • Odour: oranges

  • Flammability: flammable (flashpoint 55°C) Packaging: 1, 5, & 20L jerry cans

  • Surface Preparation

  • All oil, grease , and other contaminants must be removed (GEMPREP 2000 is recommended).

  • Concrete: Must be minimum of 4 weeks old.

  • Acid etch with 5% Hydrochloric acid, wash clean with water and allow to dry OR physically remove laitence by suitable means e.g. grinding, sweep blasting etc.

  • On previously painted concrete physically remove coating by suitable means e.g. grinding, sweep blasting etc.

  • Steel : Blast with a suitable abrasive to near white metal (SSPC 10/SA 2.5 standard).

  • If this is not possible remove loose material by mechanical cleaning or high pressure water blast until only tight rust is left.

  • Fibreglass: Abrade surface to give a good key.

  • All surfaces must be free of dust or other contaminants before applying GEMCOAT ETC.

  • Aluminium: Abrade with non metallic abrasive or grinder to give bright aluminum and a very good key ; coat within 1 hour.

  • Method of Application

  • GEMOLV 2P can used to thin specified GemCo epoxy products.

  • Recommended levels are 5% and not higher than 10% thinning.

  • Can be used as a degreaser – immersion in degreasing bath or similar is recommended

  • Handling Precautions

  • Avoid contact with eyes and skin.

  • Do not ingest.

  • Use with adequate ventilation.

  • Protective clothing ,eye protection, and gloves should be worn.

  • Do not breathe vapor or spray.

  • Keep away from children.

  • GEMSOLV is flammable so avoid sparks ,flame, heat.

 

 

 

 

 

1/3/98

 

The information provided is accurate to the best of our knowledge. We can not however anticipate all conditions under which this information and our products may be used. We therefore accept no responsibility for results obtained by the application of our products, or for their safe use and suitability. GemCo Limited sells these products without warranty and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products.

 

 

63 Hewletts Rd, Mt Maunganui. P.O. Box 4274, Mt Maunganui South, New Zealand.

Phone +64 7 572 2411 Fax +64 7 572 2415 E-Mail : info@gemco.net.nz

Website:www.gemco.net.nz