Back to Resins

 

 

 

 

 

4.152 GEMCOAT EIS

EPOXY INJECTION SYSTEM

 

 

  • Composition and Properties

  • GEMCOAT EIS is low viscosity, two pot epoxy resin for injection into concrete substrates in need of repair.

  • It is formulated at low viscosity to allow penetration into concrete substrates.

  • It has low temperature cure and will tolerate damp surfaces and less than perfect surface preparation.

  • Physical properties

  • Appearance: Base - low viscosity clear liquid Hardener - amber colored low viscosity liquid

  • Odour: low odour

  • Flammability: non flammable

  • Solids: 100%

  • Coating Type: Epoxy

  • Packaging: 2 , 8 litre , 20 two part pack

  • Mix ratio: 1:1

  • Pot Life: 1/2 hr at 20 degrees Celsius (100g mix)

  • Coverage: 5-10 sq metres/litre (theoretical - depends on substrate)

  • Dry to Touch: Typically overnight - will vary according to temperature & humidity

  • Surface Preparation

  • If subject to acid attack the concrete should be treated with caustic until a neutral pH is achieved.

  • Damp substrates can be treated but free standing water should be avoided.

  • Drill holes along crack to the depth required.

  • Method of Application

  • Add by volume 1 part hardener (part B) to 1 part base (part A) and power

  • Mix together thoroughly.

  • Apply with suitable injection equipment.

  • Small mixes (2 litres) are recommended until familiar with the product.

  • Allow to cure for 24 hours - full cure is achieved in 7 days.

  • Handling Precautions

  • Avoid contact with eyes and skin.

  • Do not ingest.

  • Use with adequate ventilation.

  • Protective clothing ,eye protection, and gloves should be worn.

  • Do not breathe vapor or spray.

  • Keep away from children.

 

 

 

 

 

 

 

1/3/98

 

The information provided is accurate to the best of our knowledge. We can not however anticipate all conditions under which this information and our products may be used. We therefore accept no responsibility for results obtained by the application of our products, or for their safe use and suitability. GemCo Limited sells these products without warranty and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products.

 

 

63 Hewletts Rd, Mt Maunganui. P.O. Box 4274, Mt Maunganui South, New Zealand.

Phone +64 7 572 2411 Fax +64 7 572 2415 E-Mail info@gemco.net.nz

 Website: www.gemco.net.nz