 
-
Composition and Properties
-
GEMREZ LR 2:1 - J is a
laminating & casting resin for jewellery
-
It is available in 2
versions - standard cure & fast cure
-
It has outstanding clarity
and UV resistance.
-
It can be tinted with the
correct tinters or dyes - contact GemCo Ltd.
-
It can be used as an
adhesive, and a clear finish coat.
-
It has low odour
-
Physical properties
-
Appearance: Base - clear
liquid ; Hardener - clear liquid
-
Solids: 100%
-
Resin type: Epoxy
-
Packaging: 1.5 litre; 3
litre; 30 litre
-
Mix ratio: 2:1 by volume
(base : hardener)
-
Pot life standard cure: 30
minutes @ 20 ° Celsius (150 ml mix)
-
Pot life fast cure: 15
minutes @ 20 ° Celsius (150 ml mix)
-
Recoat time Typical 4 - 8
hours @ 20 ° Celsius
-
Cure time: Typical 24 hours
@ 20 ° Celsius
-
Note: Pot life & cure time
will be reduced at temperatures above 20 ° Celsius
-
Surface
Preparation
-
All surfaces to be clean &
dry before use
-
-
Method of Application
-
For best results store ,
apply, & cure resin at a minimum temperature of 25 ° C.
-
Add 1 part hardener to 2
parts base (by volume).
-
Hand mix thoroughly with a
stick
-
Take care to scrape sides &
bottom of container.
-
Mixing small quantities is
recommended in hot climates.
-
Recoat within 24 hours
-
Handling Precautions
-
Avoid contact with eyes and
skin. Do not ingest. Use with adequate ventilation.
-
Protective clothing, eye
protection, and gloves should be worn. Keep away from children.
1/4/09
The information provided is accurate to the
best of our knowledge. We can not however anticipate all conditions under
which this information and our products may be used. We therefore accept
no responsibility for results obtained by the application of our products,
or for their safe use and suitability. GemCo Limited sells these products
without warranty and buyers and users assume all responsibility and
liability for loss or damage arising from the handling and use of our
products.
|
