-
Composition and Properties
-
GEMTREAD is a solvent free, low slip, self leveling two
pot epoxy floor coating.
-
It is formulated to give a hard , flexible, non skid
coating which is capable of handling most floor traffic.
-
It is formulated for areas which require low slip such as
decks , factory floors, changing rooms, toilet & shower blocks etc.
-
It can be sprayed through a hopper gun. It can be tinted
with suitable tinters – consult GemCot.
-
Tested to AS/NZS 3661:1993, Part 1 – Slip resistance of
Pedestrian surfaces.
-
Physical properties
-
Appearance: Base -
pigmented liquid ; Hardener - pigmented liquid
-
Odour: low odour
-
Solids: 100 % Coating
Type: Epoxy
-
Packaging: 2 & 4 litre ,
two part pack
-
Mix ratio: 1:1
-
Pot Life: 1/2 hour
approximately at 20 degrees Celsius (100g mix)
-
Coverage: 2-3 sq metres/litre
typical (will vary with on substrate)
-
Dry to Recoat: Typically
overnight - will vary according to temperature & humidity
-
Dry hard 24 - 48 hours for
light foot traffic typical, 7 days full cure - will vary according to
temperature & humidity
-
Shelf Life 6 months
unopened
-
Clean up Use GemCo epoxy
clean up solvent or similar
-
Surface Preparation
-
Concrete must be 28 days
old.
-
Remove laitance (alkaline
salts on the surface formed during concrete cure) by either acid etching
with 5% hydrochloric or grinding.
-
All oil, grease , and
other contaminants must be removed (GEMPREP 2000 is recommended).
-
Loose rust, scale, and old
paint must be removed.
-
If applied over GEMCOAT
EFS epoxy sealer ensure that surfaces are free of contaminants.
-
If necessary clean with
GEMPREP 2000.
-
Method of Application
-
Mix hardener & base
separately then add 1 part hardener to 1 part base and thoroughly mix
using a drill with a mixing blade.
-
GEMTREAD is preferably
applied by Wagner (or similar) hopper gun with 4mm tip – shake mix after
each application to keep non skid in suspension.
-
Dry to recoat is normally
overnight but will vary depending on temperature & humidity.
-
Cure time can be reduced
in small areas by application of localised heating (40 ° C).
-
Note: do not apply at
temperatures below 10 ° C.
-
Handling Precautions
-
Avoid contact with eyes
and skin.
-
Do not ingest.
-
Use with adequate
ventilation.
-
Protective clothing ,eye
protection, and gloves should be worn.
-
Do not breathe vapor or
spray.
-
Keep away from children.
1/3/98
The information provided is accurate to the
best of our knowledge. We can not however anticipate all conditions under
which this information and our products may be used. We therefore accept
no responsibility for results obtained by the application of our products,
or for their safe use and suitability. GemCo Limited sells these products
without warranty and buyers and users assume all responsibility and
liability for loss or damage arising from the handling and use of our
products.
|
