-
Composition and Properties
-
GEMSTICK GP is a
general purpose 1:1 mix ratio epoxy adhesive available in a resin or
paste (for vertical surfaces).
-
GEMSTICK GP
has been used in many different applications including bonding
dissimilar materials
-
It has a 1:1 mix ratio, is flexible, and adheres well to
many plastics (consult GemCo)
-
It
has been used by hobbyists , crafts , wood turners, boat builders,
flooring contractors etc.
-
Physical properties
-
Appearance: Base - high viscosity liquid Hardener - high
viscosity liquid
-
Odour: low odour Solids: 100%
-
Adhesive Type: Epoxy
-
Packaging: Small packs: 1,2,8 20 litre kits ; large packs
200 litre drums
-
Mix ratio: 1:1
-
Pot Life: Approximately 1 hr @ 20 degrees Celsius Cure:
-
Typically overnight - will vary according to temperature.
-
Surface Preparation
-
All oil, grease , loose material ,and other contaminants must be
removed.
-
Method of Application
-
Add 1 part hardener to 1
part base and thoroughly power mix.
-
GEMSTICK GP is applied by
spatula or similar.
-
Cure normally overnight
but will vary depending on temperature & humidity..
-
Handling Precautions
-
Avoid contact with eyes
and skin.
-
Do not ingest.
-
Use with adequate
ventilation.
-
Protective clothing ,eye
protection, and gloves should be worn.
-
Do not breathe vapor or
spray.
-
Keep away from children.
1/3/98
The information provided is accurate to the
best of our knowledge. We can not however anticipate all conditions under
which this information and our products may be used. We therefore accept
no responsibility for results obtained by the application of our products,
or for their safe use and suitability. GemCo Limited sells these products
without warranty and buyers and users assume all responsibility and
liability for loss or damage arising from the handling and use of our
products.
|
