-
Composition and Properties
-
GEMSOL AC is a water based etch formulated
to reduce slip on wet tiles.
-
It is recommended for use on floor tiles
with a heavy glaze
-
A test patch is recommended first
-
Areas of Use
-
Bathrooms, kitchens, swimming pools,
hospitals, rest homes, shopping centres etc.
-
Physical properties
-
Appearance: water white liquid
-
Odour: low odour
-
pH: 12-13 CORROSIVE!!
-
Packaging 5 & 20L jerry cans
-
Coverage 10-12 sq m/litre (typical)
-
Surface Preparation
-
Thoroughly clean floor to remove all
contaminants
-
Wet floor down Method of Application
-
Wear gloves, safety glasses, and protective
clothing
-
Pour a small amount of GEMSOL AC over the
area to be etched.
-
Spread evenly with sponge, leave 10 minutes
then wash off with plenty of clean water.
-
Do not allow GEMCOL AC to dry on surface or
it will affect tile appearance.
-
Do not allow in contact with metals, wall
tiles, other cleaning chemicals, or acids.
-
Etch a test area first to make sure GEMSOL
AC is suitable.
-
Handling Precautions
-
Keep away from children.
-
Highly Corrosive
-
Contact with eyes for even a short period
can cause blindness
-
Protective clothing, safety goggles, and
rubber gloves must be worn.
-
Do not ingest.
-
Do not breath spray mist or vapour
-
First Aid
-
If poisoning occurs contact a doctor or
poisons centre
-
If swallowed do not induce vomiting.
-
Give a glass of water.
-
If skin contact occurs, remove contaminated
clothing and wash skin.
-
Immediately apply Calcium Gluconate gel to
affected areas.
-
If eyes open flood with water for at least
15 minutes
-
Contains 50g/L Ammonium Bifluoride
-
UN 2817 Hazchem 2R
18.8.08
The information provided is accurate to the
best of our knowledge. We can not however anticipate all conditions under
which this information and our products may be used. We therefore accept
no responsibility for results obtained by the application of our products,
or for their safe use and suitability. GemCo Limited sells these products
without warranty and buyers and users assume all responsibility and
liability for loss or damage arising from the handling and use of our
products.
|
