-
Composition and Properties
-
GEMSTOP WB is a fast dry
highly filled water based putty with minimal shrinkage.
-
It is formulated for
stopping laminated beams, mouldings , and similar applications.
-
It is available in harder
version for plywood - GEMSTOP WB-P.
-
GEMSTOP WB can be tinted
to selected colours – consult with GemCo.
-
Physical properties
-
Appearance: White paste
(unless tinted)
-
Coating Type: Water based
-
Packaging: 2 & 20 litre
pails
-
Coverage: 1/3 metre/litre
@ 3mm DFT(theoretical - depends on substrate)
-
Dry time: Typically 3
hours - will vary according to temperature & humidity
-
Clean up: Water
-
Packaging: 2L & 20L pails
-
Surface Preparation
-
Loose material must be
removed e.g. sawdust .
-
All oil, grease , and
other contaminants must be removed .
-
Method of Application
-
GEMSTOP WB is applied by
putty knife or trowel.
-
Dry time is normally 3
hours but will vary depending on temperature & humidity and depth of
putty applied. GEMSTOP WB can be over coated with most adhesives, or
coatings providing it is sanded.
-
It is not recommended to
apply at a depth greater than 3mm.
-
For depths greater than
this apply multiple coats allowing to dry between coats.
-
Handling Precautions
-
Avoid contact with eyes
and skin. Do not ingest. Use a dust mask .Do not breathe sanding dusts.
Use with adequate ventilation. Store in a manner to avoid freezing , and
high temperatures.
21/11/02
The information provided is accurate to the
best of our knowledge. We can not however anticipate all conditions under
which this information and our products may be used. We therefore accept
no responsibility for results obtained by the application of our products,
or for their safe use and suitability. GemCo Limited sells these products
without warranty and buyers and users assume all responsibility and
liability for loss or damage arising from the handling and use of our
products.
|
