Welcome to GemCo Ltd, you can login or create an account.

SafetyCrete Dairy Shed Repair Mortar

Epoxy putty - fast cure (Patent Pending)

7.112 GEMSTOP FCII
Price Incl. GST
Select Kit Size: 

Qty:  Buy Now
   - OR -   
Epoxy putty - fast cure (Patent Pending)

GEMSTOP FC II is a solvent free 2 part fast set putty. It is formulated for stopping and filling wood , metal, concrete, fibreglass and similar substrates. It is normally tack free in 1 mm film thickness after 0.5 - 2 min cure depending on ambient temperature. It will cure at low temperatures. It is supplied in a convenient 1:1 mix ratio to be mixed with a putty knife or similar. It has been used by timber manufacturers, hobbyists , crafts , wood turners, boat builders, flooring contractors etc.

Download 7.112 GEMSTOP FCII Product Sheet

Physical properties

  • Appearance: Part A(Base) - pigmented paste Part B(Hardener) - pigmented paste
  • Odour: low
  • Solids: 100%
  • Coating Type: Epoxy
  • Packaging: 2 litre kits
  • Mix ratio: 1:1
  • Pot Life: 60 seconds at 20 degrees Celsius (20 gram mix)
  • Coverage: 0.1 square metre/litre @ 1cm DFT(theoretical - depends on substrate)
  • Cure tack free: Typically 0.5 - 2 min in 1mm thickness - will vary according to temperature & amount mixed
  • Cure hard : Typically 30-60 min - will vary according to temperature & amount mixed. Can be sanded earlier than this.

Surface Preparation

  • Loose material must be removed e.g. sawdust .
  • All oil, grease , and other contaminants must be removed .

Method of Application

  • GEMSTOP FC II is applied by mixing 1 part of part A & 1 part Part B with a putty knife or similar then applying.
  • Cure to tack free is normally 0.5 - 2 min for 1mm thickness but will vary depending on temperature and amount mixed.
  • Up to 30% extra hardener can be used in cooler conditions to speed cure.
  • GEMSTOP FC II will be slightly rubbery in the early stages of cure.
  • GEMSTOP FC II can be over coated with most adhesives, or coatings providing it is thoroughly sanded.

Handling Precautions

  • Hardener is CORROSIVE 8 and will burn skin & eyes.
  • It can also cause respiratory damage.
  • Always use with eye & skin protection.
  • Do not ingest.
  • Avoid inhalation – use in a well ventilated area or use a respirator with an organic cartridge.
  • Do not breathe sanding dusts.
  • Keep away from children.

The information provided is accurate to the best of our knowledge. We can not however anticipate all conditions under which this information and our products may be used. We therefore accept no responsibility for results obtained by the application of our products, or  for their safe use  and suitability. GemCo Limited sells these products without warranty and buyers  and users assume  all  responsibility and liability for loss or damage arising from the handling  and use of our products.

500ml Kit