Epoxy laminating resin FAST CURE
GEMREZ LR 2:1 - FAST CURE has outstanding clarity and UV resistance. It can be tinted with the correct tinters or dyes - contact GemCo Ltd. It can be used as an adhesive, and a clear finish coat. It has low odour.
Download 4.153 GEMREZ LR - FC Product Sheet
Physical properties
- Appearance: Base - clear liquid ; Hardener - clear liquid
- Solids: 100%
- Resin type: Epoxy
- Packaging: 1.5 litre; 3 litre; 30 litre
- Mix ratio: 2:1 by volume (base : hardener)
- Pot life standard cure: 30 minutes @ 20 ° Celsius (150 ml mix)
- Pot life fast cure: 15 minutes @ 20 ° Celsius (150 ml mix)
- Re-coat time Typical 4 - 8 hours @ 20 ° Celsius
- Cure time: Typical 24 hours @ 20 ° Celsius
- Note: Pot life & cure time will be reduced at temperatures above 20 ° Celsius
Surface Preparation
- All surfaces to be clean & dry before use
- Method of Application
- For best results store , apply, & cure resin at a minimum temperature of 25 ° C.
- Add 1 part hardener to 2 parts base (by volume).
- Hand mix thoroughly with a stick
- Take care to scrape sides & bottom of container.
- Mixing small quantities is recommended in hot climates.
- Re-coat within 24 hours
Handling Precautions
- Avoid contact with eyes and skin
- Do not ingest
- Use with adequate ventilation
- Protective clothing, eye protection, and gloves should be worn
- Keep away from children
The information provided is accurate to the best of our knowledge. We can not however anticipate all conditions under which this information and our products may be used. We therefore accept no responsibility for results obtained by the application of our products, or for their safe use and suitability. GemCo Limited sells these products without warranty and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products.