Welcome to GemCo Ltd, you can login or create an account.

Coronavirus Notice: GemCo is now operating under Level 1 guidelines.

GemSol Hand Sanitizer
GemSol Hand Sanitizer Details

SafetyCrete Dairy Shed Repair Mortar

Epoxy floor topping - trowel applied
10 Litre Kit

Price Incl. GST
Qty:  Buy Now
   - OR -   
Epoxy floor topping - trowel applied, 10 Litre Kit

GEMCOAT EFT is a solvent free, aggregate filled, low slip, three part epoxy floor topping. It us suitable for application over GEMCOAT EFS epoxy sealer by trowel. It is formulated to give a hard , resistant topping which is capable of handling most floor traffic, and is resistant to most acids & alkalais. It is ideal for factory floors, chemical bunds, etc. It has low temperature cure and if applied over GEMCOAT EFS will tolerate damp substrates and less than perfect surface preparation.

Download 4.164 GEMCOAT EFT Product Sheet

Physical properties

  • Appearance: Part A (Base) - clear liquid Part B (Hardener) – amber coloured liquid Part C (Aggregate) – a mixture of mineral particles
  • Odour: low odour
  • Solids: 100 %
  • Coating Type: Epoxy
  • Packaging: 10 litre , three part pack
  • Mix ratio: 1 part base: 1 part hardener: 10 parts aggregate (by volume)
  • Pot Life: 1 hour approximately at 20 degrees Celsius
  • Coverage: 2 sq metre/10 litre kit @ 5mm DFT(theoretical - depends on substrate)
  • Dry to Re-coat: Typically overnight - will vary according to temperature & humidity
  • Dry hard 24 hours for light foot traffic, 7 days full cure

Surface Preparation

  • All oil, grease , and other contaminants must be removed (GEMPREP 2000 is recommended).
  • Loose material, scale, and old paint must be removed.
  • Apply over GEMCOAT EFS epoxy sealer.

Method of Application

  • GEMCOAT EFT comes in 3 part pack with correct ratio of ingredients.
  • Add hardner to base and thoroughly mix - a drill with a mixing blade is recommended.
  • Then add aggregate slowly and thoroughly mix. GEMCOAT EFT is applied by trowel.
  • A light mist of water can be applied to EFT to assist in trowelling if required.
  • Cure to a firm surface is normally overnight but will vary depending on temperature & humidity.
  • 7 days should be allowed for full cure. GEMCOAT EFT is applied over GEMCOAT EFS epoxy floor sealer.
  • For vertical surfaces add fumed silica (consult GemCo) to GEMCOAT EFS epoxy sealer to thicken then apply GEMCOAT EFT.

Handling Precautions

  • Avoid contact with eyes and skin.
  • Do not ingest.
  • Use with adequate ventilation.
  • Protective clothing ,eye protection, and gloves should be worn.
  • Do not breathe vapour
  • Keep away from children.


The information provided is accurate to the best of our knowledge. We can not however anticipate all conditions under which this information and our products may be used. We therefore accept no responsibility for results obtained by the application of our products, or  for their safe use  and suitability. GemCo Limited sells these products without warranty and buyers  and users assume  all  responsibility and liability for loss or damage arising from the handling  and use of our products.